Woodstock W1816 owner manual Intake barrel attached to Blower housing Vacuum Pipe

W1816 Owner's Manual (Mfg. Since 10/09)

Note: In Steps 4–5below, tighten the fasteners in an alternating star pattern to obtain an even sealing pressure on the foam tape.

4.Orient the intake barrel on the blower housing as shown in Figure 10, then secure it in place with (12) 5⁄16"-18 x 3⁄4" hex bolts and (12) 5⁄16" flat washers.

Intake

Port

x 12

SETUP

5.Attach the cyclone funnel to the intake barrel with

(12)5⁄16"-18 x 3⁄4" hex bolts, (24) 5⁄16" flat washers, and (12) 5⁄16"-18 hex nuts, as shown in Figure 11.

6.Install the funnel vacuum pipe into the hole provided on the side of the funnel with (4) 5⁄16"-18 x 3⁄4

hex bolts and (4) 5⁄16" flat washers, as shown in

Figure 11.

Note: The vacuum pipe can only be positioned in one way that will allow the mounting holes to align.

The vacuum pipes and connecting vacuum hose keeps the drum collection plastic bag from collapsing during operation.

7.Attach the four upper stand legs to the blower housing brackets with (16) 3⁄8"-16 x 3⁄4" hex bolts and

(16)3⁄8" flat washers, as shown in Figure 12.

Note: Make sure the open ends of the stand legs are facing down and even with the top of the brackets.

Figure 10. Intake barrel attached to the

blower housing.

x 12 x 4

Vacuum

Pipe

Figure 11. Cyclone funnel attached and

the funnel vacuum pipe installed.

Upper

Stand

Leg

Blower Housing

Bracket

x 16

Figure 12. Upper stand leg properly

attached to the blower housing bracket.

-14-