Wybron N/A user manual Gel String Loading, CXI Specifications

Gel String Loading

The CXI gel string installation procedure is as follows:

Note: The CXI relies on the gel string being taped securely to the rollers. Be sure the roller is clean and use good quality GAFF tape. The tape length should be 2/3 of the roller length and apply the tape "lengthwise" on the roller.

1.Put the color changer on table, mounting plate down with the 4 pushbuttons toward you, remove the front cover

2.The back gel string is yellow-magenta

a.tape the "yellow end" of gel string to the lower left roller, roll the gel string onto the lower left roller

b.holding the gel string, wind up the lower right roller 6 turns and tape the gel string on

3.The front gel string is magenta-cyan

a.tape the "magenta end" of gel string to the upper left roller, roll the gel string onto the upper left roller

b.holding the gel string, wind up the upper right roller 6 turns and tape the gel string on

4.Replace the front cover

CXI Specifications

End to end speed:

3 seconds

Models: 4560, 7200, 7220, 7240 4 seconds

Models: 12210, 16130, 16050

Fan: Multiple speed - normal

		- limited
		- remote control
Fuse:	3 Amp Slo Blo
		Models: 4560, 7200. 7220, 12210, 7240
	4 Amp Slo Blo
		Models: 16050, 16130
Gelstring:	Qty 2,	23 frames each
LED Indicators:		Index mode (Yellow LED)
		Control signal present (Green LED)
		Power (Red LED)

Power supply compatibility:

Any Coloram II Power Supply

Signal termination: Not required

Weight:

4560 – 4-inch CXI Color Changer - 6.10 lbs./2.77 kg 7200 - 7.5-inch CXI Color Changer – 7.24 lbs./3.28 kg

20