HOOKING UP THE VIDEO RECEIVER
IF YOUR TV IS ALREADY HOOKED UP TO A DBS RECEIVER OR OTHER A/V DEVICE
1.Connect a set of Audio/Video cables to the A/V OUT jacks on the Video Receiver. Connect the other end to your TV (use either L or R channel for audio).
2.Plug the Video Receiver's Power Supply jack (the power supply with NO code wheels) into the Video Receiver and plug the power supply into a 120 volt wall outlet.
VIDE O A UDIO
TO TV
T V
VIDEO AUDIO
If a DBS Receiver or other A/V component is connected to the TV using A/V cables, you can connect the Video Receiver to the free LINE IN jacks on the component. If there are no LINE IN jacks, you will need to use a TV antenna splitter as described earlier.
VIDE O A UDIO
T O T V
VIDEO AUDIO
T V
3.Turn the Video Receiver's power switch (on side of unit) on.
4.Set the channel switch to the same letter as you set on the camera, A, B, C, or D.
5.Position the Video Receiver in a convenient location such as on top of the TV and orient the antenna so that the flat side points in the direction of the room where you set up the Camera/Video Sender.
IF YOUR TV DOES NOT HAVE A/V CONNECTORS
You can use the supplied coaxial cable to connect the TV OUT socket on the Video Receiver to the Antenna input on your TV. If you already have an antenna
connected to your TV, you will need to use a TV antenna splitter.
OUT
VIDEO AUDIO
IN
D S S
Set your TV and the TV Channel switch on the Video Receiver (on bottom) to the same channel (3 or 4).
TO TV
ANTENNA
TO TV VIDE O | A UDIO |
|
|
T V
12
UHF/VHF ANTENNA
12 | 13 |
