Installation, cont’d
1 2 34 5 6 7 8
Front Panel Connectors and Indicators
1&27&8
3&6 4&5
Twisted Wire Pairs
TP T 15HD 45
1
COMPUTER
2
INPUT
TP T A 45 |
1 |
AUDIO |
3 |
INPUT |
Tip (L) |
Ring (R) |
3Power input captive screw connector — Connect power input cables to the
+ | 12 VDC |
- | .5A MAX. |
|
Power Input Captive Screw
Direct Insertion Connector
Remove power before wiring.
4Digital audio output captive screw connector — Connect the digital audio output cables to the
+ | AUDIO |
Digital Audio Output
Captive Screw Direct Insertion Connector
Remove power before wiring.
Figure |
| Sleeve ( |
| ) |
|
| |||
|
1Power LED indicator — The LED lights green whenever power is applied.
2
input. | 10 5 | 1 6 |
Input only sync signals, no video |
|
|
signals, on the sync pins, 13 and 14. | 15 | 11 |
For component video, use the R | Female | |
and R return pins (pins 1 and 6), G |
|
|
(Y)and G return pins (pins 2 and 7), and B
For
For composite video, use the G pin and the associated return pin. For additional genlocked video signals, use the R, B, and associated return pins.
The TP T 15HD 45 and TP T A 45 are only compatible with the RGBHV and RGBS VTR series of receivers.
33.5 mm stereo mini jack input — Connect unbalanced audio to this stereo jack. Wire the male plug as shown below.
Input only analog and line level audio signals on this connector.
Cabling and Setup
To install the TP T 15HD 45 and TP T A 45 models, follow these steps:
1Turn all of the equipment off and, if applicable, disconnect it from the power source.
| TP T 15HD 45 and TP T A 45 • Installation |