Maintenance | en |
|
Install the Wheels
If the wheels must be removed for service, make sure they are installed as follows:
Front Wheel
1.Make sure the valve stem (1) is to the outside (see Figure 36).
2.Slide the front wheel (2) onto the spindle (3).
3.Fasten the front wheel (2) with washers (4 and 5) and cotter pin (6). Bend the ends of the cotter pin apart to keep the front wheel on the spindle.
4.If your model has hub caps (7), install the hub caps. Make sure the washers hold the hub caps in place.
| 5 |
6 | 4 |
| |
7 |
|
| 3 |
1 | 2 |
Figure 36
Bag Full Indicator Adjustment
Sliding the carriage bolt, washer, and nut (1) up de- creases the sensitivity in the bagger before the buzzer goes off (see Figure 38). Sliding the carriage bolt, washer, and nut down increases the sensitivity in the bagger before the buzzer goes off.
1.Loosen carriage bolt, washer, and nut (1).
2.Slide carriage bolt, washer, and nut up or down the buzzer lever (2).
3.Tighten carriage bolt, washer, and nut.
NOTE: It may be necessary to change the bag full indi- cator adjustment as turf conditions change.
Rear Wheel
1.Install the washers (1) and spacer (2) onto the axle
(3) (see Figure 37).
2.Mount the square key (4) in the key slot.
6 | 1 |
| 4 |
| 1 |
| 2 |
7 | 2 |
8 | |
9 |
|
5 |
|
Figure 37
3.Make sure the valve stem (5) is to the outside.
4.Align the slot in the rear wheel with the square key.
5.Slide the rear wheel (6) onto the axle (2).
6.Fasten the rear wheel (6) with washer (7) and
7.If your model has hub caps (9), install the hub caps. Make sure the washer holds the hub caps in place.
2 | 1 |
Figure 38
32
