Operation
Transport the Unit
To transport the unit, follow the steps below.
1.Push the blade rotation control down to the DISENGAGE position (see Figure 9).
2.Raise the lift lever to the highest position (see Figure 16).
3.Move the throttle control to a position between SLOW and FAST (see Figure 8).
4.To go faster, move the speed control pedal to a faster speed (see Figure 14).
Operate the Mower Deck
WARNING
The mulcher cover is a safety device. Do not remove the mulcher cover. The deflector forces the discharged material toward the ground. Always keep the deflector in the down position. If the deflector is damaged, replace the deflector with an original equipment part from an authorized service center.
IMPORTANT: When you operate with the mower deck, always operate with the throttle control in the FAST po- sition.
1.Turn the ignition switch to the ON position to start the engine (see Figure 18).
2.Move the lift lever to a height of cut position (see Figure 16). In high or thick grass, cut the grass in the highest position first and then lower the mower deck to a lower position.
3.Move the throttle control to the SLOW position (see Figure 8).
4.Slowly move the blade rotation control to the EN- GAGE position (see Figure 9).
5.Move the speed control pedal to the desired speed settings (see Figure 14).
NOTE: When you mow in heavy grass or mow with a bagger, operate the speed control pedals in the lowest speed.
en
6.Move the throttle control to the FAST position (see Figure 8). If you need to go faster or slower, stop the unit and move the speed control pedal to an- other speed setting.
7.Make sure the level of cut is still correct. After you mow a short distance, look at the area that was cut. If the mower housing does not cut level, see the instructions to “Level The Mower Deck” in the Maintenance section.
WARNING
For better control of the unit, select a safe speed.
Before Starting the Engine
Check the Oil
NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed. See the engine manufacturer’s instructions for the type of fuel and oil to use.
1. Make sure the unit is level.
NOTE: Do not check the level of the oil while the engine runs.
2.Check the oil. Follow the procedure in the engine manufacturer’s instructions.
3.If necessary, add oil until the oil reaches the FULL mark on the dipstick. Do not add too much oil.
Add Fuel
WARNING
Always use a safety fuel container. Do not smoke when adding fuel to the fuel tank. Do not add fuel when you are inside an enclosure. Before you add fuel, stop the engine and let the engine cool for several minutes.
1.Remove the filler cap (1) (see Figure 20).
2.Fill the fuel tank (2) to the FULL (3) position with regular unleaded fuel.
NOTE: Do not use premium unleaded fuel. Make sure the fuel is fresh and clean. Leaded fuel will increase deposits and shorten the life of the valves.
19
