CONNECTING UP
1. Connect a Video cable to the VIDEO OUT jack on the Video Receiver. Connect the other end to your TV's VIDEO IN jack. If your TV does not have a Video IN jack, you will need to purchase an RF modulator, or connect as shown in the diagram below.
2. Plug the Video Receiver's Power Supply jack (the power supply with NO code wheels) into the Video Receiver and plug the power supply into a 120 volt wall outlet.
3.Turn the Video Receiver's power switch (on side of unit) on.
4.Set the channel switch to the same letter as you set on the camera, A, B, C, or D.
5.Position the Video Receiver in a convenient location such as on top of the TV and orient the antenna so that the flat side points in the direction where you set up the Camera.
IF YOUR TV IS ALREADY HOOKED UP TO A
DBS RECEIVER OR OTHER A/V DEVICE,
OR IF YOUR TV DOES NOT HAVE A VIDEO
IN JACK.
If a DBS Receiver or other A/V component is connected to the TV using a COAX cable, you can connect the Video Receiver to the free LINE IN jack on the component.
FINE TUNING YOUR SYSTEM
The system usually works best with the "pip" on the Camera's antenna facing the flat side of the Receiver's antenna (see diagram below). Sometimes, however, reflections and other effects in the home may affect the signal so that some adjustment of either the Camera or Receiver antenna may be necessary to get the best signal. If you have more than one Camera, sometimes pointing the Receiver's antenna up towards the ceiling works best.
pip
CAMERA/SENDER | VIDEO RECEIVER |
SOLD SEPARATELY |
|
4 | 5 |
