Xantech 490-85 installation instructions Verify IR Receiver

4.

Verify IR Receiver.

Remove the power supply from the connecting block and all Emitters from the output. Place a jumper wire on the connecting block between IR Signal and GND. Reconnect the Power Supply. With a known good hand-held remote, shoot a constant IR Command at the receiver and verify the TB LED on the Receiver lights.

Xantech Corporation

13100 Telfair Avenue, 2/F

Sylmar, CA 91342

Phone: (818) 362-0353, Fax: (818) 362-9506

Instructions, 490-85 © 2007 Xantech Corporation

This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior

written consent from Xantech Corporation.

Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.

08905105A - 10 -