D5KP Speaker Connections

The D5XH sends a digital audio signal to connected D5KP Keypads where it is amplified and sent to speakers.

WARNING!: The D5KP’s amplifier is capable of powering a single pair of 8-6 Ohm speakers. DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more than one speaker to either speaker connector of the D5KP. In doing this, damage to the D5KP may occur and will void the products warranty.

To connect speakers to D5KP Keypads:

1.Ensure that system power is OFF!

2.Remove the SPEAKER CONNECTOR from the D5KP

3.Strip speaker wire back 1/4"

4.Loosen speaker terminal screws on the speaker connectors

5.Insert speaker wires into terminals making sure to maintain +/- polarity

6.Tighten screws on speaker terminals

7.Re-connect the terminal strip to the SPEAKER CONNECTOR on the D5KP

8.Connect speaker wires to the room speakers maintaining correct polarity

Figure 3-5: Speaker Connections

 

 

08905154B

- 16 -

Page 16
Image 16
Xantech D5XH installation instructions D5KP Speaker Connections