Pre-Construction

In a pre-construction installation, walls and ceilings are open with no drywall installed. This is desirable and allows the installer greater access than in retro-fit applications.

Before actually running any wire or cable, take the time to look around each room or area of the house and plan your wire paths for maximum efficiency. Look for routes through uncluttered parts of the stud wall or ceiling that allow you to group all low-voltage (video, speaker wires, Cat-5, telephone, etc.) wires wherever possible. It is a good practice to label both ends of all cables and to protect wires by tying a plastic bag over the ends.

Note: Do not run low-voltage wires closer than 12" from high-voltage wires. If necessary, cross low- voltage wires at a 90º angle to prevent interference.

Retro-Fit Wiring / Post Construction

Retro-fit installations are more difficult to complete than pre-construction because walls and ceilings are intact. Typically wires must be fished into position through walls, floors and ceilings.

Holes must be cut; speakers mounted directly in the ceiling or walls with no rough-in brackets and Keypads and local source wall plates must be mounted in existing drywall.

Pre-Wiring

D5XH to D5KP Keypads

The D5XH and all associated components are wired using Cat-5 terminated to the T-568A Wiring Standard (Figure 2-2). When pre-wiring, run lengths of Cat-5 from the pre-determined equipment location (the “head-end”) to each Keypad location. The Cat-5 routes all audio, power, IR and status information needed for full system operation.

Note: For maximum performance over long runs (more than 150 ft) run an additional 16AWG 2- conductor wire for external power.

1 2 3 4 5 6 7 8

Shown tab down

1 2

3 4

5 6

7 8

GREEN/WHITE

GREEN

ORANGE/WHITE

BLUE

BLUE/WHITE

ORANGE

BROWN/WHITE

BROWN

Figure 2-2: T-568A Wiring Standard

Keypads to Speakers

Run 16AWG 2-conductor stranded copper speaker wire between keypad locations and speaker locations.

 

 

08905154B

- 9 -

Page 9
Image 9
Xantech D5XH Pre-Construction, Retro-Fit Wiring / Post Construction, Pre-Wiring, Keypads to Speakers