Xantech Adding Delays, Test Macro, Advance to Source, Exit Edit Mode, Test ISM4 All Macros

Adding Delays

9.To add a DELAY after the IR Command (following Step 5), press the DELAY button. The PROGRAM LED will flash once to indicate that the ISM4 has entered delay mode.

10.Press the NEXT button once for each second of delay to be added to the IR Macro Command. Press the PREV button once for each second of delay to be subtracted. To save the Delays, press and release the SEQUENCE button.

NOTE: The first press of the NEXT button will add one second of delay. Each additional press will add one second up to 60 seconds after which the timer will reset back to 0 seconds. The first press of the PREV Button will add 60 seconds of delay. Each additional press will subtract one second down to 0 seconds after which the timer will reset to 60 seconds.

Test Macro

11.A fully programmed (Source ON or OFF) Macro can be tested by pressing the TEST button while in EDIT mode.

NOTE 1: If the IR Commands and Delays within the IR Macro Commands were not properly saved, the Macro cannot be tested and the Program LED will flash red to indicate error.

NOTE 2: To Test a Macro starting from Normal Operation Mode, Press and hold SEQUENCE until the active source blinks once and release to enter Edit Mode, (Source 1 and Program LEDs will turn ON solid green), Navigate to the Macro to be tested (2 second press of PREV or NEXT) and then press the TEST button.

Advance to Source 2 – 4

12.To advance to SOURCE 2 (from Source 1 (OFF Macro)), press and hold the NEXT button again until the SOURCE 1 LED blinks once and release. The SOURCE 2 LED and the PROGRAM LED will turn ON solid green. Repeat the sequence to advance to SOURCES 3 and 4.

NOTE: Pressing and holding the PREV button until the active Source LED blinks once, will shift programming to the previous Macro. (i.e. pressing and holding the PREV button while in SOURCE 1 (ON Macro) Edit Mode, will shift Edit Mode to the SOURCE 4 OFF Macro. (SOURCE 4 LED will turn ON solid green and the PROGRAM LED will turn on solid orange.)

13.Repeat Steps 2-11above until all SOURCE ON and OFF Macros have been programmed, tested and saved. It is vitally important to program both the SOURCE ON and OFF Macros. The ISM4 will not function properly if both sets of Macros have not been programmed.

Exit Edit Mode

14.To exit Edit Mode, press and hold the PREV button, release after the selected SOURCE LED blinks a second time (about 2 seconds apart). The ISM4 will return to Normal Operating Mode.

Test ISM4 (All Macros)

NOTE: All system devices and components must be properly setup and connected to test ISM4 Macro Programming. Be sure that all Sensors are connected to the appropriate device and the Source Sense Input Ports on the ISM4. Also be sure all IR Emitters are connected to the appropriate Source “IR Out “ Ports on the ISM4 and attached to the correct device over the IR eye for that device.

15.With all Sources OFF, turn the System Reference Device (SOURCE 1) ON. All Sources should turn ON and any additional setup programming (source select, play, etc) should execute as programmed. If any functions were ‘missed’, test the individual ON Macro for that Source. Re-learnIR Commands and adjust delays as necessary until the system powers up correctly.

16.Repeat Step 15 for System OFF. (Turn the System Reference Device, SOURCE1, OFF).