Xantech ML85 installation instructions Model, Description, Features, Specifications

INSTALLATION INSTRUCTIONS

MODEL

ML85

Micro Link™ Peep-Hole Style

Plasma\LCD\LED\CFL Friendly

IR Receiver

DESCRIPTION

The Micro Link IR Receiver is a small peep-hole style infrared repeater assembly. The Micro Link IR Receiver is equipped with a 7-foot cable and a 3.5mm stereo mini plug, which is plugged directly into the “IR RCVR” jack on the connecting block, such as the models 789-44, CB60, and 791-

44.The Micro Link IR Receiver is primarily intended for use in installations where the connecting block is within reach of its 7-foot cable – as when installing the Micro Link IR Receiver in a cabinet where the controlled equipment is behind closed doors.

FEATURES

∙Small size; mounts in 1/2” diameter hole. 2 inches deep (50mm).

∙Quick-Connect 3.5mm Stereo Mini Plug on 7ft. cable for direct plug-in to Xantech Connecting Blocks.

∙Works in normal 3-wire mode (12VDC, IR, GND).

∙Green Talkback LED for System Verification.

SPECIFICATIONS

∙Infrared modulation frequency bandwidth: 30 – 60 kHz.

∙IR reception range: Up to 80 feet, depending on remote control output strength and ambient conditions.

∙Reception angle: 55 degrees off axis for 50% range reduction.

∙Cable requirements: 3-conductor. Use 24 gauge up to 200’, 22 gauge up to 600’ 20 gauge up to 2000’, 18 gauge up to 5000’ – unshielded OK.

∙Max. transmission length: 1 mile using 18 gauge wire.

∙Maximum current output: 100mA

∙Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.

∙Dimensions: 1/2” diameter x 2” deep (13mm x 50mm).

∙Power requirements: +12VDC, 20mA.

1