AFM Antenna
Connect an outdoor FM antenna to the FM 75Ω socket. Generally, a
If standard FM broadcast frequencies are available via your cable service, you may connect your 75 ohm FM antenna jack to your cable system. Please contact your cable service to discuss this option.
BAM Indoor Loop Antenna
The
To stand the loop antenna on a surface, fix the claw to the slot.
12
Connect the loop antenna's wires to the AM antenna terminals as shown.
How to connect
Press the lever, insert the end of the cord, then release the lever. Make sure it is fastened securely by pulling the cord lightly. Make sure only the bare, stripped wire is inserted in the jack and that no plastic insulation is preventing contact between the antenna wire and terminal.
Place the antenna on a shelf, for example, or hang it on a window frame, etc., in the direction which gives the best reception, as far away as possible from the entire system, speaker cords and the power cord, to prevent unwanted noise.
<If the AM loop antenna provided does not deliver sufficient reception (often due to being too far from the transmitter or in a concrete building, etc.), it may be necessary to use an outdoor AM antenna.
Use either a high quality commercial AM antenna or, if not available, an insulated wire more than 15 ft (5 m) long, strip one end, and connect this to the terminal as shown.
The antenna wire should be strung outdoors or indoors near a window. For better reception, connect the GND terminal to a reliable ground.
Note:
Even when using an outdoor AM antenna, do not disconnect the AM loop antenna.
CAUDIO OUT
Connect the component with RCA pin cords. Make sure to connect :
white plug wwhite jack(L:left) red plug wred jack(R:right)
DPower cord (AC)
Be sure to connect the power cord to an AC outlet which supplies the correct voltage.
Hold the power plug when plugging or unplugging the power cord.
EREMOTE
Used for a wired remote control unit (optional).
FRS-232
Used for a wired
5
