Xantech XT1 user manual FM Antenna AM Antenna, Serial cable to, 3rd party device, Power Supply

Each XT1 package contains

-XT1 AM/FM Tuner with RDS/RBDS

-IR cable: 3.5mm mono socket - 3.5mm stereo jack

-Serial cable: DB9 female - RJ45 male

-Audio Cable: L/R RCA male to 3.5mm stereo female jack

-Audio Cable: L/R RCA male to L/R RCA male

-Power supply 12VDC 300mA

-FM Dipole Antenna

-AM loop antenna

-User Manual

Optional (sold separately)

-1U Rack mount kit for up to 3 tuners: Xantech part number 1U3XT1RM

FM Antenna

AM Antenna

	Serial cable to
GND
	3rd party device

Power Supply

3.5mm Mono jack to 3rd party IR output

RS232 control

The XT1 can be controlled via RS232. To connect a serial control device, the supplied serial cable should be used. This cable establishes the RS232 communication to and from the tuner.

The pin layout and RS232 protocol can be found in the back of this manual.

IR Receiver input

To control the XT1 via IR, an IR extender system needs to be used. There is no IR receiver inside the LCD display. To connect an industry standard IR extender system, use the supplied IR cable and plug the stereo jack of this cable into the IR sensor input of the XT1, and use the mono socket to attach the IR extender output to. Tip = IR-SIGNAL, Sleeve = GND.

Antenna’s

Position and secure both antennas individually until the clearest sound is heard.

4/16 XT1