Xantrex Technology 42V 10A manual Specification, Output

Specification

OUTPUT

Voltage Range:	0V to 42V minimum
Current Range:	0A to 10A minimum
Output Voltage Setting:	By coarse and fine controls.
Output Current Setting:	By single logarithmic control.
Operating Mode:	Constant voltage or constant current with automatic cross-over.
Output Switch:	Electronic. Preset voltage and current displayed when off.
Output Terminals:	4mm terminals on 19mm (0.75”) pitch.
Output Impedance:	Typically <5mΩ in constant voltage mode.
	Typically >20kΩ in constant current mode.
Output Protection:	Output will withstand up to 48V forward voltage.
	Reverse protection by diode clamp for reverse currents up to 3A.
Over-temperature	The output will be tripped off if a fault causes the internal
Protection:	temperature to rise excessively.
Load & Line Regulation:	<0.01% of maximum output for a 90% load change or 10% line
	change.
Ripple & Noise	Typically <2mVrms, <10mV pk-pk, constant voltage mode.
(20MHz bandwidth):
Transient Response:	<200µs to within 50mV of set level for 90% load change.
Temperature Coefficient:	Typically <100ppm/°C
Status Indication:	Output on lamp. Constant current mode lamp.

METER SPECIFICATIONS

Meter Types:	Dual 4 digit meters with 14mm (0.56") LEDs. Reading rate 4 Hz.
Meter Resolutions:	10mV, 10mA
Meter Accuracies:	Voltage 0.3% of reading ± 2digit,
	Current 0.6% of reading ± 2digit

GENERAL

AC Input:	Factory set for: 110V - 120V AC ±10% or 220V - 240V AC ±10%,
	50/60Hz. Installation Category II.
Power Consumption:	800VA max.
Operating Range:	+5ºC to +40ºC, 20% to 80% RH.
Storage Range:	−40ºC to + 70ºC.
Environmental:	Indoor use at altitudes up to 2000m, Pollution Degree 2.
Safety:	Complies with EN61010−1.
EMC:	Complies with EN61326.
Size:	140 x 160 x 320mm (WxHxD).
Weight:	3.6kg

3