![b) Press [ ].](/images/new-backgrounds/106039/1060393x1.webp)
7+('2&80(17&203$1<
DC230LP Windows NT® 4.0 TCP/IP Quick Install
b) Press [ ]. | RARP | = | displays. |
(current entry) | * |
c)Press [ ![Press [ ] until](/images/new-backgrounds/106039/1060393xi2.webp){kind=small}
] until the required setting
displays RARP(required entry) = 
.
d)Press [Enter]. **SAVED** displays momentarily, followed by
RARP | > . |
(your entry) |
6. Enter the Gateway Address:
a) | Press [ | ] until | Default Gateway > |
| |||
(current entry) |
|
| |||||
| displays. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
b) | Press [ | ]. | Default Gateway | = | displays. | ||
(current entry) |
| ||||||
Note: Use zeros to supplement each address segment if fewer than 3 digits are used; e.g., 13.252.25.08 = 013.252.025.008.
c)Use the [ 
] or [ 
] key to select the first digit in the Gateway Address.
d)Press [ 
] to move to the next digit. Repeat this procedure to enter the entire Gateway Address.
e)Press [Enter]. **SAVED** displays momentarily, followed by
Default Gateway | > | . |
(your entry) |
|
7. Enter the Subnet Mask:
a) | Press [ ] until | Subnet Mask > |
(current entry) |
b) Press [ 
]. 
displays.
c)Use the [ 
] or [ 
] key to select the first digit of the Subnet Mask for your network.
d)Press [ 
] to move to the next digit. Repeat this procedure to enter the entire Subnet Mask.
e)Press [Enter]. **SAVED** displays momentarily, followed by
Subnet Mask | > . |
(your entry) |
8. Enter the Broadcast Address:
Note: Broadcast Address is where all the host bits are set to either zeros (0) or ones (1).
a) | Press [ | ] until | Broadcast Addr | > |
| |
(current entry) |
|
| ||||
| displays. |
|
|
|
|
|
|
|
|
|
|
| |
b) | Press [ | ]. | Broadcast Addr = | displays. | ||
(current entry) | ||||||
c)Use the [ 
] or [ 
] key to select the first digit in the Broadcast Address.
d)Press [ 
] to move to the next digit. Repeat procedure to enter the entire Broadcast Address.
e)Press [Enter]. **SAVED** displays momentarily, followed by
Broadcast Addr | > | . |
(your entry) |
|
9. Enter the Printer (Host) Name:
Note: It is recommended that the Printer (Host) Name be the same as your Share Name.
a) | Press [ | ] until | Printer Name |
| > |
| |
(current entry) |
|
| |||||
| displays. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
b) | Press [ | ]. | Printer Name | = | displays. | ||
(current entry) |
| ||||||
c)Press [ 
] repeatedly until the cursor reaches the last character. A tone sounds indicating when the last character has been reached.
Page 2 of 4
