Installing a SIMM
Installing a SIMM
1 |
2 |
3 |
4 |
5 |
6 |
Turn off the printer and unplug the power cord. Disconnect all cables from the back of the printer.
Remove the two screws from the back of the control board, and pull the control board out of the printer.
Be aware that the control board should be connected to the inside of the printer by two cables. Do not disconnect these cables.
Align the SIMM with its connection points at the control board’s connectors at a 70o angle.
Rotate the SIMM downward into the connector until it snaps into place. Make sure both metal clips on the connector are fastened and the two pins on the connector are pushed through the holes in the SIMM.
Slide the control board back into the printer and fasten it with the screws you removed in Step 2.
Reattach cable(s) and the power cord and turn on the printer.
