Xerox FIB1-SERIAL Six-screws Terminal Block, Fiber Optic Connectors, Environment Dimension Power

Six-screws Terminal Block Application

Fiber Optic Connectors

Two connectors are provided for fiber optic cable connection.

One is for transmission and the other is for reception of optical data. (WDM transceiver has only on SC connector for bi-directional transmissions on a single fiber)

Environment		Dimension	Power
Temperature : 0℃ - 50℃(operating)		138mm x 86mm x 20mm	+12V / 1A maximum
	-20℃- 70℃ (storage)	(H x W x D)	DC plug type : center Positive
Humidity	10-90% non condensing	Weight : 300g

FIB1-SERIAL Pin Assignment (DB9 Connector for Option)

PIN	DB9
NO #	Female
1	9
2	7
3	2
4	8
5	3
6	5

TRADEMARKS

Ethernet is a registered trademark of Xerox Corp.

ST® is a registered trademark of AT&T.

WARNING:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference in which case the user will be required to correct the interference at his own expense. NOTICE: (1) The changes or modifications not expressively approved by the party responsible for compliance could void the user's authority to operate the equipment. (2) Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.

CISPR PUB.22 Class A COMPLIANCE:

This device complies with EMC directive of the European Community and meets or exceeds the following technical standard. EN 55022 - Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment. This device complies with CISPR Class A.

WARNING:

This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CE NOTICE

Marking by the symbol CE indicates compliance of this equipment to the EMC directive of the European Community. Such marking is indicative that this equipment meets or exceeds the following technical standards: EN 55022:1994/A1:1995/A2:1997 Class A and EN61000-3-2:1995, EN61000-3-3:1995 and

EN50082-1:1997