XM Satellite Radio XC9 manual Connection Options

6.Connection Options

The XR9 and Cradle provide an audio output signal in three ways:

1.FM Wireless Transmitter - When using the XC9 cradle with the wireless FM transmitter option, the XM audio signal can be received at your car radio on selectable FM frequencies using the menu options included in your XR9. (Refer to the XR9 owner’s manual.) The XM audio signal can then be played through your car radio when the car radio is tuned to one of the available frequencies.

2.FM Direct Wiring - If the FM wireless transmitter does not provide satisfactory performance in your vehicle, use the optional FM Switching Box assembly (Part No. SAT-SWB) which provides a hard-wired FM output. Connect the switching box to the FM OUT connector on the rear of the cradle; the other end of the switching box plugs into the antenna jack of your radio. By using this assembly, and selecting the appropriate FM output frequency (88.1MHz -107.9MHz) using the XR9 FM Options-Frequency Control

-13-

menu, the XM signal received at the ANT cradle antenna input can be played through your car radio when tuned to one of these fequencies.

3.Low-Level Audio Output - For vehicles equipped with radio head units with auxiliary audio inputs, the audio signal can be routed through an optional audio cable (Part No. SAT- RCA) and applied to the auxiliary inputs of a radio or entertainment system. In this case, it is best to turn the XR9 FM modulator option off to avoid interference.

XC9 CRADLE (REAR VIEW)

TO CAR RADIO

ANTENNA INPUT

DC IN￿ FM OUT￿ AUX￿ AUDIO￿ ANT￿

FM SWITCHING

BOX SAT-SWB

128-7218

13 of 20