XM Satellite Radio XC9 manual Installation/Wiring Precautions, Setting Up and Installing Your Kit

Installation/Wiring Precautions

1.To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. Connect power wires last.

2.Do not install the unit in the locations exposed to direct sunlight or, in areas subject to extreme temperatures.

3.Incorrect installation may cause damage to the system. Mount the unit firmly in place, using the supplied hardware.

4.Be careful not to damage the vehicle wiring.

5.Be sure to use the supplied screws and washers.

6.Be careful not to snag any wires when tightening screws.

7.Use only the 12 Volt-to-6 Volt DC Power Adapter supplied. Use of an alternative power adapter may damage the XR9 unit and/or the XC9 cradle.

CAUTION: You could drain the vehicle battery if the cigarette lighter adapter remains plugged in after the ignition is turned off. Unplug the adapter to prevent this possibility.

Setting Up and Installing Your Kit

NOTE: The XM signal can be received and processed virtually anywhere as long as there are no obvious satellite signal obstructions such as nearby buildings, high terrain, parking garages or tunnels.

1.Cabling Interconnections

You can begin to enjoy XM™ Satellite Radio as soon as the XR9 and Vehicle Kit installation are complete. Set up your Audiovox XC9 using the following installation instructions, or enlist the help of a professional installer:

2.Installing the Cradle Mount Base Assembly

a.Interconnect all of the components as shown on the adjacent page to verify that the system operates normally.

b.Locate a firm, reasonably flat surface within your car to permit optimum viewing and line-of-sight access by the supplied remote control unit.

-7-

128-7218

7 of 20