Xpelair Digitemp manual it couldn’t be simpler

Fix the bracket

...it couldn’t be simpler!

Installing Digitemp from within the room at high or low levels requires only a standard 13 amp electrical supply.

Designed for low cost installation, Digitemp is simple to fit requiring only two discreet holes to an external wall. Using a patented folding grille system, Digitemp can be installed entirely from inside the property making it ideal for apartments and multi-storey locations - eliminating the cost of erecting scaffolding.

When operating in cooling only mode, condensate is removed through water evaporation on the condenser therefore a drainage pipe is not necessary. In models with a heating function, the unit requires condensate to be removed through a small drainage pipe.

Only external evidence is two discreet grilles

1 Select the position of the unit (see diagram for optimum positioning). Where possible the unit should be positioned towards the centre of the selected external wall

2 Drill holes for vents at a sloping angle to the external wall to allow for drainage in heating mode

3

4 From within the room, feed the discreet folding grilles through the inlet and outlet vents

5 Hard wire the unit to a ring main spur