TROUBLESHOOTING
DIAGNOSTIC LED’S
The Red LED indicates that the amplifier is on.
The Yellow LED indicates that an
The Orange LED indicates that an
SYMPTOM/CONDITION | CAUSE | SOLUTION |
Red LED not on. No Sound. | Loss of 12V Power at Amplifier | Check |
|
| Check +/– 12 Volt connections |
|
| Measure for + 12 Volts or higher |
|
| @ amp. Check |
Red LED on. No Sound. | No Input Signal | Check integrity of RCA cables |
|
| Check connection at amp and |
|
| head unit. |
Red LED on. No Sound. | Loose Speaker Wires | Check integrity of speaker |
|
| connection at amp and speakers. |
Red LED on. No Sound. | Lack of | Voltage @ |
|
| to be 8 Volt minimum |
Red LED on. No Sound. | Missing Accessory Port Jumper | Check Port Jumpers, two jumpers |
|
| per port are required. Check |
|
| jumper alignment, jumper must |
|
| be seated properly. |
Red LED on. No Sound. | Accessory module is not | Be sure “key” on module connector |
| installed properly | and port are aligned when |
|
| installing module. Reseat module |
|
| to insure proper connection. |
Alternator/System Noise | Induced noise / ground loop | “Enable” Balanced Input |
18