GLOSSARY
The following terms are used in this manual. Since they may be unfamiliar, the following definitions are provided.
Bridging: Combining two amplifier channels into one channel. Typically used to create a
Gain:The ratio of output voltage to input voltage. The gain on the M Series amplifiers has two different areas of adjust- ment. The input gain jumper offers 40 dB of input gain adjustment while the front panel potentiometer offers 15 dB of amplifier output level adjustment.
LED:Light Emitting Diode. The M Series uses 3 colored LED’s to indicate the operational status of the amplifier. A RED LED for power on/off, YELLOW for low impedance protec- tion and ORANGE for thermal protection.
Load Impedance: Measurement of speaker(s) resistance/reactance that the amplifier must drive. The M Series protection circuitry engages when a load impedance of less than 2 Ω’s is present.
Mixed Mono: The amplifier’s ability to play the Left and Right Stereo channels while playing a third (bridged) mono channel.
Module Port: 18 pin connector located inside the M Series amplifiers designed to connect Xtant’s accessory modules. Each M Series amplifier has two Module Ports for every two channels of input.
PWM:Pulse-Width Modulated power supply. Our regulated PWM maintains a high conversion efficiency over an input supply range of
Remote
5