10 EZ-AG
Setting Up
This section contains information about setting up your EZ-AG for playing. Make sure to read
this section carefully before using the instrument.
Although the EZ-AG will run either from an optional AC adaptor or batteries,
Yamaha recommends use of an AC adaptor whenever possible. An AC adaptor is
more environmentally friendly than batteries and does not deplete resources.
■ Using an AC Power Adaptor • • • • • • • • • • • • • • • • • • • • • • • • •
qMake sure that the [STANDBY/ON] switch of the EZ-AG is set to STANDBY.
wConnect the AC adaptor (PA-3C, PA-3B, or other adaptor specifically recom-
mended by Yamaha) to the DC IN 12V jack.
ePlug the AC adaptor into an AC outlet.
■ Using Batteries • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
For battery operation the EZ-AG requires six 1.5V “AA” size, or LR6 or equiva-
lent batteries. When the batteries need to be replaced, the volume may be
reduced, the sound may be distorted, and other problems may occur. When this
happens, turn the power off and replace the batteries, as described below
qOpen the battery compartment cover located on the instrument’s bottom panel.
wInsert the six new batteries, being careful to follow the polarity markings in
the battery compartment.
eReplace the compartment cover, making sure that it locks firmly in place.
Power Requirements
• Use ONLY a Yamaha PA-3C or
PA-3B AC Power Adaptor (or
other adaptor specifically rec-
ommended by Yamaha) to
power your instrument from
the AC mains. The use of other
adaptors may result in irrepa-
rable damage to both the adap
-
tor and the EZ-AG.
• Unplug the AC Power Adaptor
when not using the EZ-AG, or
during electrical storms.
AC Adaptor
PA-3C
• Use only alkaline batteries for
this instrument. Other types of
batteries (including recharga-
ble batteries) may have sudden
drops of power when battery
power becomes low, possibly
resulting in loss of data in the
flash memory and the need to
initialize the flash memory.
• When the batteries run down,
replace them with a complete
set of six new batteries.
NEVER mix old and new batter
-
ies.
• If the instrument is not to be in
use for a long time, remove the
batteries from it, in order to
prevent possible fluid leakage
from the battery.
8