PLAYING BACK TUNES FROM YOUR iPhone/iPod
Using a Wireless System for iPod
■Establishing a wireless connection
Once the iPhone/iPod is connected to the transmitter and playback begins, it takes about 5 seconds for audio to be heard. During this time the wireless connection between the transmitter and receiver is established.
The status of the wireless connection between the transmitter and receiver is indicated by the respective status indicator.
Status of | Transmitter | Receiver |
connection | indicator | indicator |
|
|
|
No connection | Off | Off |
|
|
|
Confirming connection | Green, flashing | Blue, flashing |
|
|
|
Connected | Green, lit | Blue, lit |
|
|
|
■Controlling this unit with your iPhone/
iPod
•When playback begins on an iPhone/iPod that is connected to a transmitter, and if the transmitter is within range of the receiver, this unit performs as follows:
–If this unit is already turned on when playback begins: The input source switches to DOCK.
–If this unit is in standby mode when playback begins: This unit turns on and the input source switches to DOCK.
•Adjusting the volume on the iPhone/iPod also adjusts the volume of this unit. Note that the iPhone/iPod can only be used to increase this unit’s volume to a certain level; to increase it further, adjust the volume using this unit’s VOLUME control or the remote control.
•In the following situations, the wireless connection between the transmitter and receiver is disconnected. After 30 seconds this unit automatically enters standby mode.
–The iPhone/iPod is not operated for about
–The sleep timer of the iPhone/iPod is activated.
–The iPhone/iPod is disconnected from the transmitter.
–The iPhone/iPod battery level decreases to a level where it cannot provide enough power to the transmitter.
–The transmitter is moved outside of the wireless communication range of the receiver.
–Communication between the transmitter and receiver becomes disrupted due to interference from other wireless LAN devices, cordless telephones, microwave ovens, etc.
y
•You can use the remote control to control the iPhone/iPod. For more information, see page 11.
•When this unit is turned on or is in standby mode, your iPhone/ iPod can be charged automatically if the transmitter connected to your iPhone/iPod is stationed to the receiver. If an iPhone/ iPod is charged while this unit is in standby mode, the POWER on indicator lights up brightly.
•Refer to the operating instructions of the
