Using the PURE DIRECT switch

 

PHONO (MM/MC) switch

 

 

 

You can enjoy the purest possible sound from your audio sources by setting this switch so that the indicator lights up. By doing so, the audio signals bypass the BASS, TREBLE, BALANCE, LOUDNESS controls, SUBSONIC FILTER switch, MODE switch and the PRE OUT/MAIN IN terminals, thus eliminating any alterations to the audio signals.

Select either MM or MC position depending on your PHONO cartridge, Moving Magnet or Moving Coil type. However, if you use a high output MC cartridge, select MM position.

To select the MC position, press this switch so that it is held inward. To select the MM position, press this switch so that it is released outward.

PURE

PHONO

DIRECT

 

 

 

 

 

 

MC

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MM

Setting the SUBSONIC FILTER switch

If you set this switch to “ON” position, undesirable ultra-low- frequency signals caused by turntable rumble or warped records can be cut out without losing sound quality.

Setting the MODE switch

This switch can be used for switching between stereo and monaural operation. Normally this switch should be set to the STEREO position.

SUBSONIC

 

 

 

 

 

MODE

 

 

FILTER

 

 

 

 

 

 

 

 

 

ON

 

 

 

 

 

 

 

MONO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OFF

 

 

 

 

 

 

 

STEREO

 

 

 

 

 

 

 

Open/close the control door

When it is not necessary to operate controls inside the control door, close the door.

To open the door

To close the door

12