CONTROLS AND THEIR FUNCTIONS
FRONT PANEL
1 2 3 45 6 |
| 7 | ||
| l | 9 |
| INPUT |
NATURAL SOUND STEREO AMPLIFIER AX |
|
| ||
|
|
|
|
|
STANDBY/ON |
|
|
|
|
|
|
|
|
|
|
| PURE | TAPE |
|
|
|
|
|
|
|
|
| DIRECT | MONITOR | AUX | TAPE | MD | CD | TUNER | PHONO |
|
|
SLEEP |
|
|
|
|
|
|
|
|
|
|
PHONES | SPEAKERS |
|
| PURE |
| TAPE |
| BASS |
| |
| A | B |
|
| DIRECT |
| MONITOR |
| ||
|
|
|
| 0 |
| |||||
|
|
|
|
|
|
|
| |||
| ON | ON |
|
|
|
|
|
|
|
|
| OFF | OFF |
|
|
|
|
|
| – | + |
|
|
|
|
|
|
|
|
| ||
8
VOLUME
0 l0
TREBLE | BALANCE | ||
| 0 |
|
|
– | + | L | R |
9 0 A B C
1Power indicator
Lights up while the power to this unit is on.
2STANDBY/ON switch
Press this switch to turn the power to this unit on. Press it again to turn this unit into the standby mode.
Standby mode
In this state, this unit consumes a very small quantity of power to receive
3Remote control sensor
Receives signals from the remote control transmitter.
4SLEEP indicator
Lights up while the
5PURE DIRECT indicator
Lights up while the PURE DIRECT switch is on.
6TAPE MONITOR indicator
Lights up while the TAPE MONITOR switch is on.
*When the tape deck (TAPE) is selected as the input source, this indicator will not light up even if the TAPE MONITOR switch is on.
7INPUT selector and indicators
When turned, selects a program source to listen to. The indicator for the currently selected source lights up.
8VOLUME control
Used to raise or lower the volume level.
9Control door
See page 12 for how to open and close the control door.
D | E |
0 PHONES jack | PHONES |
When you listen with headphones, | |
connect the headphones to the | |
PHONES jack. |
|
When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position.
ASPEAKERS switches
Set the switch A or B (or both A and B) for the speaker system (connected to this unit) you will use to the ON position. Set the switch for the speaker system you will not use to the OFF position.
BPURE DIRECT switch
You can enjoy the purest possible sound from your audio sources by pressing this switch so that the PURE DIRECT indicator lights up. By doing so, the audio signal bypasses the BASS, TREBLE and BALANCE controls, eliminating any alterations to the audio signal.
CTAPE MONITOR switch
When the tape deck connected to the TAPE terminals on the rear of this unit is used for recording, you can monitor the sounds being recorded by pressing TAPE MONITOR so that TAPE MONITOR indicator lights up.
DTone controls
BASS
Used to increase or decrease the low frequency response. The 0 position produces flat response.
TREBLE
Used to increase or decrease the high frequency response. The 0 position produces flat response.
EBALANCE control
Adjusts the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions.
8
