LOADING AND PLAYING DISCS
You can load or replace five discs at a time.
1Press OPEN/CLOSE to open the disc tray and load discs.Use the disc guides to align the discs correctly in the tray.
Label side upward
Disc tray
Note
To play back an 8 cm (3 inch) CD, place it in the inner recessed area of the disc tray. Do not put a normal (12 cm (5 inch)) CD on top of an 8 cm CD.
2Press OPEN/CLOSE to close the disc tray.3Press MODE to select a desired disc play mode (1DISC or 5DISC) confirming it on the display.
1DISC: Only the selected disc is played back.
5DISC: All discs on the tray are played back in sequence.
4Press (Play) to start playback from the first track or file of disc 1.5(If necessary) Select a desired disc by using DISC SKIP / , or a DISC
Program playback Audio CD
In the program playback mode, you can play back tracks in a programmed sequence.
Notes
•You can program and play back tracks in any order from all of the loaded discs
•The programmed tracks are erased when the disc is ejected, this unit is turned off, or this unit is turned to the standby mode.
This unit is set to the program editing mode.
2Select a disc with one of the DISC
You can program up to 24 tracks.
y
To cancel the programmed track, press CLEAR.
5Press .Playback starts from the beginning of the programmed sequence.
y
To erase all programmed tracks, press CLEAR when the playback is stopped.
PLAYXCHANGE
PLAYXCHANGE is a function that allows you to replace discs during disc playback without interrupting it.
Press the PLAYXCHANGE button on the front panel to open the disc tray and replace discs.
CAUTION
Never try to load a disc in the position marked x in the figure below. This may cause damage to the unit and the disc, because that is where the disc being played back is located.
Note
DISC SKIP buttons do not work while the disc tray is open.