CONTROLS AND FUNCTIONS
Rear panel connections
CAUTION
Before making any connection, switch OFF the power to the unit, the amplifier and any other component.
(supplied) | cable Audio | cable | digital Optical |
REMOTE CONTROL | AC IN inlet | |
| IN/OUT terminals |
|
The audio signals are only output from the ANALOG OUT jacks when the PURE DIRECT mode is on.
Amplifier
Connect the supplied power cable into the AC IN inlet on the rear panel when all connections are complete, and then plug in the power cable to the AC outlet.
■VOLTAGE SELECTOR
(Asia and General models only)
CAUTION
The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.
Voltages are as follows:
...............AC
230- | Voltage indication |
240V |
|
VOLTAGE
SELECTOR
For Custom Installer
■REMOTE CONTROL IN/OUT terminals
These terminals are used for custom installation system. When this unit is connected to the components for custom installation system, you can operate this unit with the system remote control.
Connect the REMOTE CONTROL IN terminal of this unit to the output terminal of the central controller for custom installation system.
By connecting the REMOTE CONTROL OUT terminal of this unit to the input terminal for remote control of the other component, you can also operate it with the system remote control. In this way, up to 6 components can be connected in series.
■RS-232C terminal
This unit is also equipped with an