Notes

●You can program as many as 40 tracks at one time.

●If you choose to perform programming with the DISC 1 tray empty, be sure to press a DISC SKIP button before starting programming.

●You can program a whole disc by pressing “0”, instead of one track. At that time, “AL” flashes in the display.

●If you will program tracks from more than one disc, before you press the PROG button, check the total recorded time of each disc on the disc tray by pressing the DISC SKIP button in turn. Without this operation, the total time of the programmed tracks will not be displayed during programming.

●The total time of the programmed tracks will not be displayed, if a track number higher than 20 is programmed.

●If, during programming, the TIME display mode-select button is pressed, the program number display can be changed to display the total time of the programmed tracks or no information. To return to the previous display, press the TIME display mode-select button once again.

●The SKIP ( and ) buttons can be used during playing, but only within the range of the programmed tracks.

●The SEARCH ( and ) buttons can be used during playing to search through all tracks, including unprogrammed tracks.

To stop program play

Press the STOP button. The first programmed track number will be displayed.

To resume play, press the PLAY button. Play will begin from the beginning of the program.

To cancel a programmed sequence

There are several methods, as described below.

●Press the STOP button while the unit is stopped.

●Open the disc tray.

●Switch off the power.

●CDC-555 only

Press the CLEAR button while the unit is stopped.

To check programmed data

1.If during program play, press the STOP button.

2.Press the PROG button.

3.Each time the SKIP button is pressed, the track numbers and sequential order of the programmed tracks can be checked one after another. The display of the track number can be returned (sequentially in reverse order) by

pressing the SKIP button.

To correct programmed data

1.Follow the procedure described in “To check programmed data”.

2.Display the track number to be corrected by pressing the SKIP button.

3.Press a numeric button to select a track to replace the one displayed. The previously programmed track will be cleared from the memory and the new one will be programmed.

4.After the correction has been completed, press the PROG button or PLAY button once again.

15