Yamaha CDX- 590, CDX-890, CDX-490 BASIC OPERATION, PLAY, Notes, POWER, RANDOM, OPEN/CLOSE, PLAY/PAUSE, OUTPUT LEVEL, To turn off the power, ➂CDX-590and CDX-490only

This manual describes how to operate this unit by using the remote control transmitter.

To operate this unit on the front panel, use the corresponding buttons on the front panel.

BASIC OPERATION

	SYNCHRO	DIMMER	TIME	OPEN/	2, 3
				CLOSE
1	SPACE PEAK	TAPE	CLEAR	PROG
	POWER	2	3
	1			INDEX
	4	5	6	+I0
	7	8	9	0
		REPEAT RANDOM
			SEARCH
	– OUTPUT LEVEL +		SKIP		4
	STOP	PAUSE	PLAY
1 Turn the power on.	3 Close the disc tray.
	POWER

OPEN/

CLOSE

2 Load a disc.	Label side
	upward	4
OPEN/		PLAY
CLOSE

Disc tray Play will begin from the first track of the disc.

Display information at disc play					Notes
	➀	➁		➂	• After closing the disc tray by pressing the OPEN/CLOSE
					button, the display shows the total number of tracks and the
					total recorded time of the disc for a few seconds.
			SINGLE
	3 4 5 6 7 8 9 10 11 12					TOTAL
						1 2 3 4 5 6 7 8 9 10 11 12

➃

➀Shows the track number selected or being played.

➁Shows the time displays. (Refer to “Selecting time displays” on page 10.)

➂CDX-590 and CDX-490 only

Shows the level of signals output into an amplifier or the headphone level adjusted by using the OUTPUT LEVEL button.

➃Displays the numbers that correspond to the numbers of tracks (as high as number 20) on the disc. After each track is played, its corresponding number disappears so the number of remaining tracks (and their numbers) can be seen at a glance.

•Additionally, you can close the disc tray by pressing the PLAY (PLAY/PAUSE) button, a numeric button or the RANDOM button, or by pressing the front edge of the disc tray gently. If the tray is closed in these ways, play will begin automatically, however, the display will not show the total number of tracks and the total recorded time of the disc.

To turn off the power

Press the POWER switch again.

8