Yamaha Digital Mixing Engine, DME32

AES/EBU

AES/EBUAES/EBU

AES/EBU

DME32

AD824 DA824

Split AES/EBU Cable

A 16-Channel I/O sytem using AES/EBU transmission. Up to 200 meters of separation between the DME32

and the I/O components is possible.

In the example above, a split AES/EBU cable is utilized to connect the DME32 to the AD824

and DA824. See the next section for details on creating this cable.

Since no Wordclock signal is sent to the AD824 units in either the AES/EBU or ADAT

connection examples, Wordclock BNC Cables must be run from the DME32 to the AD824.

Please see Chapter 13 (page 227) of the DME32 Owner's Manual for more information on

Wordclocks.

WORDCLOCK SOURCE SETTING CAUTION

When the wordclock source is changed on the wordclock master device (e.g. AD824 or DME32),

noise may occur from the DA824's analog outputs, especially if an MY8-AT I/O card is installed, so

turn down your power amps, or turn off the DA824 beforehand, otherwise any connected speakers

may be damaged.

BNC Cable (wordclock)