Menu structure

 

 

 

 

 

■ 4 <SETUP>

 

 

 

 

Menu item

 

Selections

 

 

 

 

 

LOCATION

 

 

 

FRONT/TABLE, FRONT/CEILING, REAR/

There are four ways of installing this unit; tabletop or ceiling mounting for front or rear projection. The

TABLE, REAR/CEILING

DPX-1000 will invert or rotate the projection according to this setting.

 

 

KEYSTONE

 

–100 to 0 to +100

If the projection unit is at a horizontal or perpendicular angle to the screen the projection image will be

 

distorted to a trapezoid shape. Use the KEYSTONE setting to electronically correct without increasing

 

the length of the image. Increase the value when the top of the image is overly wide, and reduce the

 

value when the lower part of the image is too wide.

 

 

When the upper part of the image is wider than the lower

When the lower part of the image is wider than the top

Increase the value in the positive (+) direction

Decrease the value in a negative (–) direction

REMOTE CONTROL SENSOR

 

 

FRONT&REAR/FRONT/REAR/OFF

 

Use this parameter for switching between the 2 sensors located on the front and rear of the main unit that

receive signals from the remote control. You can operate the main unit with a wired remote regardless of

how this parameter is set.

 

REMOTE CONTROL ID

 

 

ID 1/ID 2

 

The main unit can receive commands from the remote control if you set the same ID in the main unit as

is set by the code change switch on the side of the remote control. Use this code change switch to allow

one remote to control two main units independently.

 

LENS ADJUSTMENT LOCK

OFF/ON

Locks the lens so that the V. POS, ZOOM, and FOCUS settings cannot be changed accidentally. Set to

OFF to cancel this function.

 

WHITE BOOST

OFF/ON

Enhances the luster of the white part in the projected image.

 

ECONOMY MODE

OFF/ON

Lowers power supply to the lamp by approximately 20% to prolong its life.

 

MENU COLOR

 

 

 

 

MONOTONE/COLOR

 

 

Selects the color of the characters and background for the on-screen menu display. Press the + or

button to access the submenu and change color selections.

 

MESSAGE

OFF/ON

Set whether to display messages of any type on screen.

 

TRIGGER OUT

 

 

LAMP/FAN/RS-232C

 

Set the external control TRIGGER OUT terminal 12V signal emission to “LAMP” to synchronize it to

the ON/OFF state of the lamp, to “FAN” to synchronize it to the fan, and to “RS-232C”, to receive ON/

OFF signals through the RS-232C terminal.

 

BAUD RATE

 

 

9600bps/19200bps/38400bps/57600bps/

 

Sets the transmission speed of the RS-232C terminal.

115200bps

This setting becomes valid from the next time you switch the unit on.

 

MENU

English

E-21