- | + | - | + |
Connecting the power cord
After completing all connections, connect the AC power cord to an AC power outlet
Note:When the player is in the “STANDBY” mode, it is still consuming some power. If you wish to disconnect your player completely from the power, press the POWER button.
Caution: Only qualified service personnel should remove the cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1Open the battery compartment cover.
2Insert batteries as indicated inside the battery compartment.
3Close the cover.
Caution: Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television’s
1Press the POWER button on the front panel of the DVD player to turn off the DVD player.
2Press and hold 9 and ^/T on the front of the DVD player.While holding 9 and ^/T , press the POWER button.
3After PAL or NTSC appears on the display panel of the DVD player, release 9 and ^/T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting.
4To change the setting, press ^/T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.
16PREPARATION