35
English
Troubleshooting

Refer to the chart below when this unit does not function properly. If the

problem you are experiencing is not listed below or if the instruction below does

not help, set this unit to the standby mode, disconnect the power cord, and

contact the nearest authorized YAMAHA dealer or service center.

Problem Solution

No power – Check if the AC power cord is properly connected.
– Press the STANDBY/ON on the front of the DVD system
to turn on the power.
No picture – Refer to your TV’s manual for correct Video In selection.
Change the TV input until you see the DVD screen.
– Check if the TV is switched on.
–If you did not use Progressive Scan connections (using the Y
PB PR jacks on the DVD Player) and you do not have a
picture at the TV, please follow the steps below to turn off
Progressive Scan;
1. Press / (OPEN/CLOSE) to open the disc tray.
2. Press 1.
3. Press ANGLE to deactivate the Progressive.
➜The DVD Player will reset itself to Component/Interlaced
video.
Distorted picture –Sometimes a small amount of picture distortion may appear
depending on the disc being played back. This is not a
malfunction.
Completely distorted picture
or black/white picture with
DVD
– Make sure the disc is compatible with the DVD Player.
– Ensure that the DVD Player’s TV Type is set to match that
of the disc and your TV.
No sound or distorted sound – Adjust the volume.
– Check that the speakers are connected correctly.
No audio at digital output – Check the digital connections.
– Check if your receiver can decode MPEG-2 or DTS and if
not, please make sure the digital output is set to
PCM ONLY.
– Check if the audio format of the selected audio language
matches your receiver capabilities.
No sound and picture – Check that the RGB/SCART cable is connected to the
correct device (See “Video Connections”).