1
2
1
2
Ground (earth) Lead
Diameter:
0.12mm (0.005 in)/ampere
EX;
10 Ampere → 1.2 mm (0.05 in)
AE00088
CONNECTION NOTES
9Avoid connecting the generator to commercial power outlet.
9Avoid connecting the generator in parallel with any other generator.
1Correct
2 Incorrect
AE00091
CONNECTION
w
Before the generator can be connected to a build- ing’s electrical system, a licensed electrician must install an isolation (transfer) switch in the build- ing’s main fuse box. The switch is the connection point for generator power and allows selection of generator or main line power to the building. This will prevent the generator from charging the main power line (backfeeding) when the main power sup- ply has failed or has been turned off for line repair. Backfeeding can electrocute or injure line mainte- nance personnel. Also, generator and building electrical system damage can occur when normal operating power returns if unit is used without an isolation switch.
AE00086
EXTENSION CORD NOTES
9When using an extension cord, its total length should not exceed
60 meters for cross section of 1.5 mm square
and
100 meters for cross section of 2.5 mm square.
9This extension cord should be protected by a tough flexible rubber sheath (IEC 245) or the equivalent to withstand mechanical stresses.
– 7 –
