Yamaha EMX512SC 1 2 3, 1

BASIC

6EMX512SC/EMX312SC/EMX212S

Quick Guide

Before Turning On the Mixer

■Connecting to Power

1Be sure that the POWER switch is in the OFF position.

2Connect the included power cord to the AC IN connector on the rear panel.

3Plug the power cord into a standard power outlet.

■Turning the Unit On and Off

NOTE

•To prevent an unpleasant burst of noise from the speakers, you should power up the sound sources ﬁrst, and then the other devices in

order of their distance from the source (starting with the closest).

For example: Sound source (external device)

→

EMX unit

→

Amps (Powered speakers)

When turning power off, proceed in the opposite order.

•Before turning power on, make sure that the LEVEL and MASTER knobs are set to the “0” position.

1Push the POWER switch in to turn the power ON.

The power lamp lights up to indicate that power is on. To turn the power off, push the switch again, so that it

pops out.

Contents

Main 2 Explanation of Graphical Symbols IMPORTANT SAFETY INSTRUCTIONS CAUTION PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING Do not open * Please keep this manual in a safe place for future reference. WARNING FCC INFORMATION (U.S.A.) About this Manual Mixer Basics (starts on page 6) EMX Setup and Operation (starts on page 20) IMPORTANT NOTICE FOR THE UNITED KINGDOM Basic Contents Features Quick Guide 6 Making the Most of Your Mixer 13 Reference 1 2 3 Turning the Unit On and Off 1 RIGHT WRONG!! 1 (microphones, instruments, etc.) Getting Sound to the Speakers Page 4 the LINE/MIC switch on each channel accordingly. 5 your inputs, set the PHANTOM switch to the ON position (). 7 tion. as necessary to adjust the overall output level. 8 9 1 depth for each channel. 2 To select a reverb effect, turn the dial to any value from 1 to 7. 3 4 overall effect depth. Using the Compressors to Enhance Vocals 1 (EMX512SC and EMX312SC only) Making the Most of Your Mixer An Introduction A Place for Everything and Everything in its Place A Plethora of ConnectorsWhat Goes Where? 14 Balanced, UnbalancedWhats the Difference? How Do Balanced Lines Reject Noise? A balanced cable has three conductors: To summarize Signal Levels and the Decibel Making Better Mixes 60 dBu Approaching the MixWhere Do You Start? Faders Down To EQ or Not to EQ Cut for a Cleaner Mix Boost with Caution Ambience Reverb and Delay Time Reverb Tone Reverb Level The Modulation Effects: Phasing, Chorus, and Flanging Compression Music FirstThen Mix Controls and Connectors Controls on Each Channel 6 7 8 9 22 Digital Effects Section 0 A 0 D MAIN Section MONITOR Section POWER Section P Q U R Rear Panel 2+ 2- V W X Connecting Speakers Page Horizontal Orientation, Tilting and Rack Mounting Tilting Rack Mounting How to install the rack-mount hardware Setting Up Setting Up Monitor Speakers Synthesizer Drums 1 Troubleshooting Specications General Specications Input Characteristics Output Characteristics Dimensional Diagrams Unit: mm Page http://www.yamaha.co.jp/manual/ CANADA U.S.A. MEXICO NORTH AMERICA CENTRAL & SOUTH AMERICA EUROPE AFRICA MIDDLE EAST ASIA OCEANIA