Performance Mode
164
[F2]: PART
Lets you edit any one of the 16 parts that make up a
performance. The parameters that can be set are the
same as those explained for the MLT (multi) screen.
[F4]: MIX
[F5]: LYR (Layer)
[F6]: SOUND (Sound)
[F7]: CTRL (Controller)
[F8]: PRE (Preset)
[F4]: MIX
These parameters are mainly related to output settings
such as volume, pan and effect send levels. With these
settings you can obtain just the right balance between
each part in the mix.
■Part
Selects the part you will edit. When a part is
selected, the current parameter settings for the
selected part will be displayed.
When “L” is selected, you can adjust the overall
settings (such as volume and pan) for the parts
which “Layer Switches” (LYR menu) are turned on.
Mix ([F4]) and Sound ([F6]) menus are available for
“L” parts.
❏ Settings: L, 1~16
In the PART screen and the MLT screen (explained next),
the part that you want to edit can easily be displayed using
the PART 1-16 keys on the panel (EX5/7 only).
■Bank (Voice Bank)
Selects the Bank which contains the voice you want
to use for the part. A different Bank can be selected
for each part.
❏ Settings: P1 (Preset 1), P2 (Preset 2), I1 (Internal 1), I2
(Internal 2)
■Number
Selects the voice number that you want to use from
within the selected voice bank. When a number is
selected here, the selected voice name is displayed to
the right of the voice name. A different voice
number can be selected for each part.
❏ Settings: 001~128 (For information about each voice, see
the Voice List in the separate Data List book.)
■Volume
Adjusts the volume of each part. These settings let
you control the volume balance of each part.
❏ Settings: 0~127
■Pan
Adjusts the panning position for each part. These
settings let you position each part in the stereo
spectrum.
❏ Settings: L63 (far left)~cnt (center)~R63 (far right)
■Out Select (Output Select)
Selects the output for each part. These settings let
you send each part to a different output.
❏ Settings: L&R (OUTPUT L&R), ind1 (INDIVIDUAL
OUTPUT1), ind2, ind3, ind4, ind5, ind6, i1&2
(INDIVIDUAL OUTPUT1&2), i3&4, i5&6,
Drum
For example, when “i1&2” is selected, the L channel
will be output from INDIVIDUAL OUTPUT1, and the
R channel from INDIVIDUAL OUTPUT2.
EX5 and EX5R are equipped with two Individual
Outputs (1 and 2) while EX7 is not equipped with the
Individual Output. You can increase/equip the
Individual Outputs on your instrument by installing an
optional Individual Output Board (EXIDO1). For more
information, see page 278.
When “drum” is selected for the drum voice (part), the
drum elements in the drum voice will be output
according to the output destinations set for each
element in the Output Select (page 146) of the Voice
Edit mode.
■Detune
Sets the detune value for each part. Detune is
effective for making the sound thicker by raising or
lowering the pitch of each element in fine
increments or decrements in relation to each other.
❏ Settings: –128~0~+127
Performance/E/qx 5/21/98 11:35 AM Page 164