EXi8/EXo8 Owner’s Manual 13
Alert list
Flashing [SIGNAL]
indicator
(alert number)
MeaningResponse
1 The device has not started up correctly. Turn the power off, then turn on after waiting at least 6 seconds. If this
does not solve the problem, please initialize the memory. Should this
also fails, contact your Yamaha dealer.
2The current preset saved in internal
memory has been lost. Recall the preset. If this does not solve the problem, contact your
Yamaha dealer.
3The word clock master has become
unlocked. Make sure that the word clock signal is being input correctly.
4There is a problem with the connection
of the [YDIF IN] connector. Make sure that YDIF cables are properly connected.
Use cables that meet the required specifications.
5
Duplicate IP addresses. Change the IP addresses or UNIT ID so that there are no duplicates.
IP address was not set within 60 sec-
onds of startup.
Please check rear panel DIP switch 6 (IP SETTING). If DIP switch 6 is
set to “PC,” use the system’s dedicated application software or the
DHCP server to specify the device IP address.
Too many devices are connected to the
network. Reduce the number of devices connected to the network.
6
The UNIT ID is set to “00.” Set the UNIT ID to something other than “00.”
Devices with identical UNIT IDs were
found connected within the same net-
work. Change the UNIT ID so that there are no duplicates.