METER SELECT section 15
GA32/12, GA24/12—Owner’s Manual
METER SELECT section
You can select the signal source to be displayed in the Meter bridge
section.
ASource select switch
This switch enables you to select the signal source to be displayed on
the MATRIX (PFL•AFL/TAPE) meter (Meter bridge 3) in the right
corner of the level meter.

■ When the switch is set to PFL-AFL/TAPE ( )

The meter indicates either the PFL/AFL bus output level or the input level of the signals sent
from the TAPE IN jacks, depending on the setting of the Monitor source select switch in the
C-R MONI section.

■ When the switch is set to MATRIX ( )

The meter indicates the output level of Matrix 1 and 2.
Meter bridge
This peak level meter indicates the output level of the MIX buses, ST bus, Matrixes 1/2, PFL
bus, and AFL bus, and the level of the signal input from the TAPE IN jacks.
AM1–M10 meters
These meters indicate the output level of MIX OUT 1–10.
BST1 meters
These meters indicate the output level of ST1 OUT.
CMATRIX (PFL•AFL/TAPE) meters
These meters indicate the PFL/AFL bus level, input level of signals sent from the TAPE IN jacks,
or the output level of Matrixes 1/2, depending on the selection made in the METER SELECT
section.
DPOWER indicator
When the power to the GA32/12 (or GA24/12) is turned on, this indicator lights up.
EPHANTOM indicator
This indicator lights up when any of the phantom power supplies (see page 16, rear panel 4)
are turned on.
METER SELECT
PFL•AFL/TAPE
MATRIX
1
PEAK
+8
+5
+3
+1
0
–1
–3
–5
–7
–10
–15
–20
PEAK
+8
+5
+3
+1
0
–1
–3
–5
–7
–10
–15
–20
PEAK
+8
+5
+3
+1
0
–1
–3
–5
–7
–10
–15
–20
PHANTOM
POWER
M1 M2 M3 M4 M5 M6 M7 M8 M9 M10 LST1 MATRIX
R12
PFL•AFL / TAPE
LR

21 3 4

5