Yamaha HTR-5930 ■Using Virtual CINEMA DSP, ■Listening to unprocessed input signals, OFF, AUTO, BASIC, OPERATION, Direct DIRECT, For 2CH STEREO:, Panorama PANORAMA

For 2CH STEREO:

Direct DIRECT
Function:	2-channel stereo direct. Bypasses the
	decoders and DSP processors of this unit
	for pure hi-fi stereo sound when playing
	2-channel analog sources.
Choices:	AUTO, OFF

y

•The “AUTO” setting bypasses the decoders and DSP processors only when “BASS” and “TREBLE” are set to 0 dB (see

page 24).

•When multi-channel signals (Dolby Digital and DTS) are input, they are downmixed to 2 channels and output from the front left and right speakers.

•The low-frequency signals input from the front left and right speakers are redirected to the subwoofer in the following cases:

–“BASS” is set to “BOTH” (see page 54).

–“FRONT” is set to “SML” (see page 54) and “BASS” is set to “SWFR” (see page 54).

For PRO LOGIC II Music:

Panorama PANORAMA

Function:	Sends stereo signals to the surround
	speakers as well as the front speakers for
	a wraparound effect.
Choices:	OFF, ON
Dimension DIMENSION
Function:	Gradually adjusts the sound field either
	towards the front or towards the rear.
Control range:	–3 (towards the rear) to +3 (towards the
	front), initial setting is STD (standard).
Center width CT WIDTH
Function:	Adjusts the center image from all three
	front speakers to varying degrees. A
	larger value adjusts the center image
	towards the front left and right speakers.
Control range:	0 (center channel sound is output only
	from center speaker) to 7 (center channel

sound is output only from front left and right speakers), initial setting is 3.

SOUND FIELD PROGRAMS

■Using Virtual CINEMA DSP

Virtual CINEMA DSP allows you to enjoy the CINEMA DSP programs without surround speakers by creating virtual speakers.

If you set “SURR” to “NONE” (see page 54), Virtual CINEMA DSP activates automatically whenever you select a CINEMA DSP program (see page 31).

Note

Virtual CINEMA DSP will not activate even when “SURR” is set to “NONE” (see page 54) in the following cases:

–When “2CH STEREO” (see page 31) is selected or when this unit is in the “STRAIGHT” mode.

–When the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 25).

–When headphones are connected to the PHONES jack.

■Listening to unprocessed input signals

When this unit is in the “STRAIGHT” mode, multi- channel sources are decoded straight into the appropriate channels without any additional effect processing. 2- channel stereo sources are output from only the front left and right speakers.

1Press AMP on the remote control and then STRAIGHT to select “STRAIGHT”.

AMP STRAIGHT

ENT.

2To deactivate the “STRAIGHT” mode, press STRAIGHT on the remote control again so that “STRAIGHT” disappears from the front panel display.

The sound field program is turned back on.

y

You can also select “STRAIGHT” by pressing STRAIGHT on the front panel.

OPERATION BASIC

33