Operation
●Check fuel line connections to be sure they are tight (if equipped Yamaha fuel tank or boat tank).
●Be sure the fuel tank is positioned on a se- cure, flat surface, and that the fuel line is not twisted or flattened, or likely to contact sharp objects (if equipped Yamaha fuel
tank or boat tank).
EMU27130
Controls
●Check throttle, shift, and steering for proper operation before starting the engine.
●The controls should work smoothly, without binding or unusual free play.
●Look for loose or damaged connections.
●Check operation of the starter and stop switches when the outboard motor is in the
water.
EMU27150
Engine
●Check the engine and engine mounting.
●Look for loose or damaged fasteners.
●Check the propeller for damage.
●Check that the battery is in good condition
and the battery connections are secure.
EMU27163
Checking the engine oil level
1.Put the outboard motor in an upright po- sition (not tilted).
2.Remove oil dipstick and wipe it clean.
3.Completely insert the dipstick and re- move it again.
4.Check the oil level using the dipstick to be sure the level falls between the upper and lower marks. Fill with oil if it is below the lower mark, or drain to the specified level if it is above the upper mark.
1 
ZMU04257
1. Oil dipstick
1.Lower level mark
2.Oil dipstick
3.Upper level mark
NOTE:
Be sure to completely insert the dipstick into the dipstick guide.
EMU30021
Filling fuel
EWM00060
WARNING
Gasoline and its vapors are highly flammable and explosive. Keep away from sparks, cigarettes, flames, or other sources of ignition.
1.Remove the fuel tank cap.
2.Carefully fill the fuel tank.
3.Securely close the cap after filling the tank. Wipe up any spilled fuel.
25