Operation
EMU27784
Reverse (automatic reverse lock and power trim and tilt models)
EWM00190
WARNING
When operating in reverse, go slowly. Do not open the throttle more than half. Otherwise the boat could become unstable, which could result in loss of control and an accident.
Tiller control models
1.Place the throttle grip in the fully closed position.
2.Move the gear shift lever quickly and firm- ly from neutral to reverse.
Remote control models
Pull up the neutral interlock trigger (if equipped) and move the remote control lever quickly and firmly from neutral to reverse.
EMU27820
Stopping engine
Before stopping the engine, first let it cool off for a few minutes at idle or low speed. Stopping the engine immediately after operating at high speed is not recommended.
EMU27851
Procedure
1.Turn the main switch to “
” (off).
2.After stopping the engine, disconnect the fuel line or close the fuel cock if there is a fuel joint or a fuel cock on the boat.
3.Tighten the air vent screw on the fuel tank cap (if equipped).
4.Remove the key if the boat will be left un- attended.
NOTE:
The engine can also be stopped by pulling the lanyard and removing the clip from the engine stop switch, then turning the main switch to “
” (off).
EMU27861
Trimming outboard motor
The trim angle of the outboard motor helps determine the position of the bow of the boat in the water. Correct trim angle will help improve performance and fuel economy while reducing strain on the engine. Correct trim angle depends upon the combination of boat,
29