Yamaha mLAN8E , Cursor , , In (input), 2,

English

Settings on the device in which the mLAN8E is installed

Cursor 2 In (input)

■

Knob 1

[ turn] Move cursor / switch pages

Move the cursor or switch pages.

[ press] Tree View

Access the Tree View screen.

■

Knob 2

[ turn] In (select input plug)

Select the mLAN8E mLAN plug that will input the signal. If a connection has already been

made, the module name and plug name will be displayed in parentheses.

❑

Setting:

AD-L, AD-R, MIDI

■

Knob 3

Display only

If unconnected, this will indicate “New.”

[ press] mLAN_INIT (mLAN initialize)

Initialize mLAN-related settings. This will be executed after you reply to a conﬁrmation dialog

box.

All connection settings will be set to “---”. The Word Clock Mode will be “Auto.”

The Nickname settings will not be initialized.

■

Knob 4

[ turn] Select connected module

Select an mLAN device on the mLAN bus (system). When you select a valid mLAN device, the

top line will show the vendor name and the Nickname.

■

Knob 5

[ turn] Select connected mLAN plug

Select an mLAN output plug on the connected mLAN device.

The connection is executed by CONNECT (press knob 5). If after making

your selection, you change pages, move the cursor, or change the Out or

Connect# settings without executing CONNECT, the selected value will be

cleared.

If there are no plugs that can be selected, this will be displayed as “---.”

[ press] CONNECT

Connect to the mLAN output plug of the selected mLAN device.

If the node number is “New,” this function will appear if you have selected a module name or

plug name that can be connected.

[ press] CUT (disconnect)

Break the selected connection.

This function will appear if you have selected an already-connected module name or plug

name.

NOTE