Yamaha MW10 Master Control Section

Front & Rear Panels

MW10 Owner's Manual

English

Master Control Section

1PHANTOM +48 V Switch

This switch toggles phantom power on and off. If you set

the switch on, the mixer supplies power to all channels

that provide XLR mic input jacks (CHs 1, 2, 3/4, 5/6). Set

this switch on ( ) when using one or more condenser

microphones.

nWhen this switch is on, the mixer supplies DC +48 V

power to pins 2 and 3 of all XLR-type MIC INPUT jacks.

•Be sure to leave this switch off ( ) if you do not

need phantom power.

• When tuning the switch on ( ), be sure that

only condenser mics are connected to the XLR

input jacks (CHs: 1 to 5/6). Devices other than

condenser mics may be damaged if connected to

the phantom power supply. Note, however, that

the switch may be left on without problem when

connecting to balanced dynamic microphones.

•To avoid damage to speakers, be sure to turn off

ampliﬁers (or powered speakers) before turning

this switch on or off. We also recommend that you

turn all output controls (ST Master LEVEL Con-

trol, etc.) to minimum settings before operating

the switch, to avoid risk of loud noises that could

cause hearing loss or device damage.

2RETURN Control

Adjusts the level of the signal sent from the RETURN

jacks (L (MONO) and R) to the Stereo bus.

nIf you supply a signal to the RETURN L (MONO) jack

only, the mixer outputs the identical signal to both the L

and R Stereo buses.

32TR IN/USB Control

Adjusts the level of signals received via 2TR IN, as well

as the level of signals received by the MW10 from the

computer via the USB interface.

42TR IN/USB Switch (TO ST/TO C-R)

Determines whether the stereo signal received via the

2TR IN connectors or USB interface is sent to the stereo

bus or the C-R OUT connectors and PHONES jack (level

meter).

n• When the 2TR IN/USB switch is set to TO ST, the

signal input via the 2TR IN/USB connector is added

to the stereo bus.

• When the 2TR IN/USB switch is set to TO C-R, the

signal input via the 2TR IN/USB connector is directly

sent to the C-R OUT/PHONES connector, and is not

output via the stereo bus.

5ST Master LEVEL Control

Adjusts the signal level to the ST OUT jacks.

6C-R/PHONES LEVEL Control

Controls the level of the signal output to the PHONES

jack and the C-R OUT L and R jacks.

7Level Meter

This LED display shows the level of the signal fed to the

Stereo bus. The “0” point corresponds to the standard

output level. The indicator lights up red when the output

hits the clipping level.

8POWER Indicator

This indicator lights up when the mixer’s power is ON.