Yamaha NS-325F PLACING THE SPEAKERS, REMOVING THE FRONT COVER, SPECIFICATIONS, ■Using as 2ch stereo speakers, ■Using as front speakers in a multi channel system

PLACING THE SPEAKERS

■Using as 2ch stereo speakers

Better stereo images will be obtained when the speakers are slightly angled in towards the listeners.

■Using as front speakers in a multi channel system

Position the speakers on both sides of the TV. The positioning of speakers is important, because it controls the whole sound quality of a multi channel system. Set up the speakers on the basis of your listening position by following the owner’s manual supplied with your amplifier.

NS-325F

Front

Subwoofer

Center

Surround back

Surround

Note:

This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away from the TV set.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at six points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the six holes on the inner surface of the cover with the six corresponding pegs on the speaker and push gently.

Note:

When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools.

SPECIFICATIONS
Type .............................	2-way bass reflex speaker system
	Magnetic shielding type
Driver ......................................	13 cm (5”) cone woofer x 2
	3 cm (1”) dome tweeter
Impedance ...................................................................	6 Ω
Frequency Response ...................	40 Hz to 50 kHz (-10dB)
Nominal Input Power ...................................................	50W
Maximum Input Power .............................................	200 W
Sensitivity ..................................................	88 dB/2.83 V/m
Crossover Frequency .............................................	2.5 kHz
Dimensions (WxHxD, with the stand)
.....................................................	304 x 984 x 326 mm
	(11-15/16” x 38-3/4” x 12-13/16”)
Weight ..................................................	16 kg (35 lbs.5 oz.)

●Specifications subject to change without notice due to product improvements.

●Care should be taken not to exceed the input power values noted above.

E-4