■To mount the speaker on a wall by using the attached mounting bracket

Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws.

*Make sure that the screws are securely caught by the narrow parts of the holes.

Tapping screw (3.5 – 4 mm) (Available at the hardware store)

3 mm Min.

20 mm

Wall/ Wall SupportWARNING

•This speaker weighs 5.5 kg (12 lbs. 2 oz.). Do not mount it on thin plywood or a wall with soft surface material. If mounted, the screws may come out of the flimsy surface and the speaker may fall. This damages the speaker or causes personal injury.

•Do not install the speaker to a wall with nails, adhesives, or any other unstable hardware. Long- term use and vibrations may cause it to fall.

•To avoid accidents resulting from tripping over loose speaker cable, fix it to the wall.

CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.LoosenTightenBlack (–)Red (+)
Speaker (R)

Speaker (L)

 

SPEAKERS

 

R

L

Speakers output

 

A

terminals of the

+ – –

+

amplifier

 

B

 

Amprifier or

 

 

Receiver

 

Connections

•Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of the amplifier (or receiver) with the speaker cable.

•Connect the (+) terminals on the amplifier (or receiver) and the speaker using one side of the cable. Connect the (–) terminals on both components using the other side of the cable.

•Connect the speaker to the center terminals of the amplifier (or receiver) making sure not to reverse the polarity (+, –). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

■How to Connect:

1Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

Good No Good

2Loosen the terminal knob.3Insert the bare wire.

4Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the

cable at the terminal.

Note

Do not let the bare speaker wires touch each other to avoid damaging the speaker or the amplifier, or both of them.

[Using a Banana Plug]2Banana Plug

1 3

1Remove the speaker terminal cover by gently pulling it toward you.2Tighten the terminal knob.3Simply insert the banana plug into the terminal.

2