How to install
This is the recommended installation procedure when the material of the installation location is plasterboard.
1Position the cutout template where you are installing the speaker.
2Trace a line around the template with a pencil. The mark for the center of the hole is also required.
3Drill the pilot hole at the center mark made on the ceiling.
WARNING•When using a drill or cutting tool, use safety goggles for eye protection and be sure to observe all safety precautions.
4To check the space behind the hole, insert a bent sturdy wire (such as a coat hanger) into the hole, and then slowly rotate the wire to check for any obstruction.
•If there is any obstruction, patch the hole and select another location.
360°
5Insert the tip of a keyhole saw into the pilot hole, and then cut all of the way around the circular outline.
WARNING
•When using a keyhole saw or cutting tool, use safety goggles for eye protection and be sure to observe all safety precautions.
6Pull the speaker cable out of the hole which you have cut.
•Leave some extra length of cable when pulling the cable out.
7Connect the speaker cable to the speaker.
•For detailed instructions, refer to page 6
“CONNECTING YOUR AMPLIFIER/RECEIVER”.
8Place the speaker into the ceiling.
CAUTION
•When installing the speaker, do not touch the tweeter dome or woofer cone directly. This may cause a malfunction.
•Make sure that mounting clamps are turned inward when installing the speaker in a ceiling.
English
4En