9Insert the speaker into the hole. Loosen four screws approximately one turn counter- clockwise. It will allow the clamps to open easily.

Loosen

Evenly tighten each of the four mounting screws clockwise using a Philips screwdriver. (At this time, these four mounting clamps open in the ceiling. These opened clamps will press the ceiling board and the speaker together to secure the speaker.) Tighten screws until the mounting clamps sufficiently grip the ceiling. Tighten the screws firmly to secure the speaker to the ceiling.

Tighten

10 Adjust the angle of the tweeter.

•Gently press the outer edge of the tweeter housing toward the listening position.

•This tweeter movable angle is about 15θ in multiple directions.

*15°

*15°

*Tweeter movable angle

CAUTION

•When adjusting the tweeter, do not rotate it. This may cause the breakage of the tweeter.

11 Attach the speaker grille to the speaker.

•As several magnets are on the speaker frame, attach the grille to the frame directly. When attaching the grille, make sure that the grille is attached to the speaker securely to keep the grille from falling.

CAUTION

•When tightening the screws, do not screw too tightly. This may cause breakage of the mounting clamps and fracture of the wallboard.

•We recommend using only hand tools as power screwdrivers may over-tighten the screws. Should you use a power screwdriver be certain to select a very low torque setting to prevent damage to the speaker or to the wallboard.

•Make sure that none of the screws are loose and that there are no gaps between the speaker and the ceiling.

HINT

• Tighten the screws in order of opposite sides rather than

clockwise or counter-clockwise￿ ￿ direction (such as right and left,

then top and bottom).

￿ ￿

CAUTION

•Be very careful when removing the grille, as it may fall or cause injury. Also, try to place an equal amount of pressure on the circumference when removing the grille. The grille may bend if too much pressure is placed in one location.

5En