Yamaha NS-P116, NS-P110 owner manual Using the Yamaha Speaker Stand SPS-80 option

Mounting the front/rear speakers (and rear center speaker for NS-P116)

1	Tapping screw
	(Available at the
	hardware store)
	Diam. 3.5 to 4 mm

Wall/wall	support
70 mm	70 mm

10 mm

Min.

20 mm

2

70 mm

Using the Yamaha Speaker Stand SPS-80 (option)

By using the Yamaha Speaker Stand SPS-80, speakers can be placed on the floor.

Mount the front/rear speakers (and rear center speaker for NS-P116) on a shelf, rack or directly on the floor, or hang them on the wall.

Holes

To mount the speakers on a wall by using the holes on the speakers’ back panels

1 Fasten screws into a firm wall or wall support as shown in the figure.

2 Hang the speaker by mounting the holes on the protruding screws.

*Make sure that the screws are securely affixed by the narrow parts of the holes.

WARNING

●Each speaker weighs 0.9 kg (2 lbs.). Do not mount them on thin plywood or a wall composed of a soft surface material. If mounted, the screws may pull out of the flimsy surface and the speakers may fall. This may damage the speakers or cause personal injury.

●Do not affix the speakers to a wall using nails, adhesives, or any other unstable hardware. Long- term use and vibrations may cause the speakers to fall.

●To avoid accidents resulting from tripping over loose speaker cables, fix the cables to the wall.

●Select an appropriate position on the wall to mount the speaker so that no one will injure his/her head or face.

SPS-80

* The SPS-80 is not available in some areas.

E-5